![]() ![]() The operating panel is locked when symbol lights up. Maximum continuous operating time buttons simultaneously for three Exit expert "menu" 2. Anti cycling How to lock the operating panel 1. 8.2 Locking and unlocking the operating panel Auto reset The operating panel can be locked, which means that the buttons do not function and no settings can be changed accidentally. Operating the controller 8.1 Setting the outlet pressure. 14 Pressure indication table SCALA2 Note The pressure settings 4.5, 5.0 and 5.Įnglish (GB) 8. As a result, no leakage will be detected. 1 5 2 6 Under normal conditions, the leaking liquid will evaporate. The time required for this depends on the operating conditions, that is, every time the operating conditions change, a new run-in period will be started. Product introduction 6.1 Product description When the pump is started up for the first time, or when the shaft seal has been replaced, a certain run-in period is required before the leakage is reduced to an acceptable level. Warning L TM06 4372 2115 H Before making any connections in the product, make sure that the power supply has been switched off and that it cannot be accidentally switched on. The overview is only intended as a guide. Warning The electrical connection must be carried out by an authorised electrician in accordance with local regulations. 4 5 min1 Mains water pressure boosting 7 Pos.ģ.6 Suction pipe length The overview below shows the different possible pipe lengths, depending on the vertical pipe length. It requires a minimum space of 430 x 215 x 325 mm (17 x 8.5 x 12.8 inches).ģ.5 Installation examples H2 3.5.1 Mains water pressure boosting Inlet pipe must be submersed at least 0.5 m (1.64 ft) 3.5.3 Suction from freshwater tank 1 1 2 2 7 3 9 4 3 4 6 2 8 3 Fig. ![]() 3.1.1 Minimum space The pump can be installed in small spaces such as a cupboard. ![]() We recommend that you install the pump near a drain or in a drip tray connected to a drain in order to lead away possible condensation from cold surfaces. 3.1 Location The pump can be installed indoors or outdoors, but it must not be exposed to frost. Installing the product Make sure that the pump is not stressed by the pipework. Sections 1-4 give the information necessary yo be able to unpack, install and start up the product in a safe way. Installation and operation must comply with local regulations and accepted codes of good practice. Prior to installation, read this document and the quick guide. Warning These installation and operating instructions describe Grundfos SCALA domestic water supply pumps. GRUNDFOS INSTRUCTIONS SCALA Installation and operating instructionsĮnglish (GB) English (GB) Installation and operating instructions Original installation and operating instructions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |